SUPPORT.

Videos and tips on how to apply 4&2Impact products.

Clean and degrease your hands and the surface you are going to protect.

Remove one by one the different pieces of kit already cut.

Apply the adhesive on the surface area to be protected, from the center to the periphery
and gradually remove the liner.

If necessary use a hair dryer or a similar equipment to facilitate the grip on curved surfaces.

Check if the surfaces have the necessary consistency for subsequent removal or glue and adhesive films.

Although we produce products of the highest quality, 4&2 Impact is not responsible for the application of its products without prior consultation.


If in doubt, please contact us for further information on the application of the products.

Application by Product Category

Clean and degrease your hands and the surface area to protect (we suggest to use a paper towel
and alcohol).
Underscore the desired aplications already cut.
Apply the adhesive on the surface area to be protected from the center to the periphery and gradually removing the liner if necessary.
You can also use an hairdryer or similar equipment for easy adhesion on curved surfaces.

Degrease and clean your hands and the surface area before apply (we suggest to use a paper towel and alcohol).
Do not stretch the tape more than 2 times the original lenght.

Clean and degrease your hands and the surface before apply (we suggest to use a paper towel and alcohol or a degreaser).
Should start and finish in the area of the valve, overlaping about 10 cm over the valve hole.


 

If in doubt, please contact us for further information on the application of the products.

Video
4&2 Impact Application on BTT Bicycle (MTB)

4&2 Impact Application on Road Bicycle

How to Apply 4&2 Impacts Protection Film (Spanish)

Bike Mechanic Life Ep.1

FOLLOW US